WEB翻訳では意味がつかめません。和訳おねがいしたいのですが。
WEB翻訳では意味がつかめません。和訳おねがいしたいのですが。
FuEL Low fuel light setup
? Press and release the switch until “FUEL” is displayed, then press and hold the switch until “ - ” is displayed.
? The display will show “oFF” or “oN”. Press and release the switch to change to the desired setting.
? Press and hold the switch until “ - ” is displayed to select the setting.
? OFF turns the low fuel function off and disables the low fuel light on the Dakota Digital gauge so it will never turn on.
? Turning the function on will access the following menus
o donE (exits the setup and also displays current desired turn-on ratio)
o tESt (displays the ratio of the fuel level sender voltage to battery voltage)
o rESEt (changes setting to the default of most stock gauges approximately 41% or ? tank)
o Adjust (used to set a custom level from 26 - 49% about ? tank to empty)
? Press and release the switch to select the desired fuel setup menu, then press and hold it to select it until “ - ” is displayed,
then release the switch to view or go on.
? A press and hold will save the setting or exit back to the menu.
? done is the first menu displayed, a press and hold will exit fuel set up at this point. The number displayed on the speedometer
is what the desired turn-on ratio is currently set at. 41 is default; 26-49 is a custom setting.
? Test will display the current fuel sender value as a percentage of sensor voltage/ battery voltage for diagnostic purposes. If
this number is greater than the number displayed in the done menu, the low fuel light will be on.
? rESEt will save the value back to factory default setting of 41%(1/4 tank of fuel).
? Adjust should only be done with the desired amount of low fuel in the tank. Once the level is where you would like the low fuel
light to turn on, press and hold the switch to save the value. It must be between 26-49, or the value will not save.
